Edit & Regenerate

Fix wording, bullets, and header fields — or strike an item the engineer won't quote — then rebuild the draft. To add equipment or change models/quantities, re-run the job from the drawings instead.

Header

Project name Project address MEP engineer Submitted to Proposal no. Proposal date Drawings dated

Intro paragraph

Item A —

Remove this item from the proposal (engineer strike — by-others, quoted separately, or not confirmed)

Tag(s)	Model	Voltage	Qty
CH-1, CH-2	YLAA0048HJ17XC		2

Voltage is editable — use schedule format (e.g. 208/1/60, 460/3/60); leave blank to keep as-is. Tags / models / quantities are locked — changing those is a scope change; re-run the job. One bullet per line below, no • needed.

Includes (29)

Galvanized Steel Construction with Baked on Powder Paint
R454B Low GWP Refrigerant
Control Transformer
Single Point Power, Circuit Breaker w/ Lockable Handle, 65kA SCWR
Starter Type: Across the Line Starter
TEAO Fan Motors
Low Sound Fans with VSD
Double Thick Evaporator Insulation
Brazed Plate Heat Exchanger
Non-Powered Convenience Outlet
Requires a dedicated electrical feed
Post-Coated Microchannel Coils (Environment Guard Basic)
Service Isolation Valves
Both Low/High Ambient Kit (-10F to >115F Unit Operation)
Wire/Louvered Encl Panels (factory)
Hot Gas Bypass - 1 circuit
Permits compressor unloading to 5% capacity based on operating conditions
Acoustic Compressor Blankets
Chiller Startup Assistance
Pre-Startup Checklist must be completed, signed, and returned to schedule startup
SC-Equip Board with BACnet
Electronic Expansion Valves
Piping Extension Kit
Extends Liquid Connections from Evaporator to the Edge of the Unit
Standard Ground Shipping to First Location
Warranty:
All unit manufacturers policies and unit registration requirements must be followed by installing contractor
12 months from start up or 18 months shipment (not to exceed 18 months) Whole Unit
5-Year Compressor parts only

Not included (9)

Cancel Regenerating overwrites the draft .docx for this run and re-runs QA (~15s).

Drafts only — every proposal is completed by an engineer before it is sent. No pricing is ever generated.